Drainage Aid (P Micro P)

Application

P MICRO-P is recommended to be used after preparing the solution in range of maximum upto 5 GPL concentrations and the final concentration at the point of addition should be 0.5 GPL. The best point of addition is in thin stock after the pressure screen and after the point of addition of retention aid.

Solution Preparation

To prepare a ready to use polymer solution it is recommended to use suitable make-down equipment which provides a homogenous and lump free solution and a minimum holding time of 60 minutes prior to application. In-line filtration of the polymer solution is recommended.

P-MICRO-P is an anionic copolymer of acrylamide/ sodium acrylate to enhance drainage phenomenon without affecting the formation of paper and board.

Product P MICRO-P
Appearance Viscous Milky Liquid
pH (0.2% solution) 7±1
Bulk density 1.0±0.05
% NVS 37±3
Emulsion Charge Anionic
Shelf Life 6 Months

COPOLYMER OF ACRYLAMIDE / SODIUM ACRYLATE

Material Safety Data Sheet

This chemical is declared in "NON-HAZARDOUS" category

Chemical Handling Instruction

  • Wear protective gloves
  • Wear protective shoes - Spilled substance increases risk for slipping
  • Do not flush with water. Dam up. Soak up with neat absorbent material. If liquid has been split in large quantities clean up promptly by scoop or vacuum.

Action in case of contact with Chemical

  • Wash with plenty of soap & water
  • Does not cause harm/irritation to skin
  • In case of swallowing of the chemical immediately allow vomiting & contact doctor
  • Fish - LC50/Fathead minnows/96h>1000mg/l
  • Algae - EC 50 / Selenastrum capricornutum /96h >500 mg/l
  • Bioaccumulation - The product is not expected to bioaccumulate.
  • Degradability / Persistence - Readily biodegradable